SOFT STARTER

Standard Features

• 200-600V, 50/60Hz input power supply
• Built-in run rated (AC1) By-pass contactor up to 820 A*
• Rated 450% current
• Conformal coated circuit board
• Voltage ramp or current limit start modes
• Detachable keypad with dual display (LCD and LED) and copy function
• 90-250Vac auxiliary control voltage
• Single 32 bit RISC processor based control board
• IP00 protected chassis enclosure
• Six isolated 24Vdc programmable digital inputs
• Three programmable relay outputs (2 AMP-250V)
• One 0-10Vdc programmable analog output
• One 4-20mA programmable analog output
• Motor PTC thermistor input
• RS-232 serial interface
• Adjustable acceleration and deceleration ramps (1 -299 seconds)
• Adjustable pedestal voltage (25 – 90% of line voltage)
• Diagnostic features: Motor overload, over current and phase loss, motor immediate over and under current, SCR over temperature and fault, line phase loss and phase sequence, line over and under voltage
• Display readings: Motor current, voltage, kW and power factor, line voltage and frequency, four last fault trips, run and power-up timers
• Ambient: 32°F (0°C) to 131°F (55°C), 3300 ft (1000m) altitude, 90% non-condensing humidity

Soft-starters are drives designed for the smooth acceleration and deceleration of three-phase induction motors by controlling the voltage applied to the motor. Microprocessed and fully digital, the SSW06 line of soft-starters was developed with cutting-edge technology, ensuring the best performance in the start and stop of induction motors.

The line has an advanced operating interface that allows easy parameter setting, built-in Pump Control function, providing effective pump control, in addition to the torque control function, which allows accelerations and decelerations with linear speed ramps.

SSW06 can contel control Motor PTC thermistor input and can be add PT100 Controller Convertor in optional.